Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEMUSB JACK REPLACEMENT
2009 Honda CR-V EX, 2.4 RE3
USB Jack Replacement
2009 Honda CR-V EX, 2.4 RE3SECTION USB Jack Replacement
SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.
- Remove the access panel from the passenger's tray (see PASSENGER'S TRAY REMOVAL/INSTALLATION ).'
- Disconnect the USB adapter cable 5P connector and the USB cord 5P connector.
- Remove the screw, then remove the USB jack (A) from the access panel (B).
- Install the USB jack in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.