Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Troubleshooting - B-CAN System Diagnosis Test Mode C
Do this diagnosis if a component that is controlled by the B-CAN system does not stop or turn off.
- If the component does not operate or turn on, go to B-CAN System Diagnosis Test Mode D (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE D ).
- See the B-CAN system unit input/output index for a list of input and output devices and the control units that monitor the input and controls the output devices (see HDS INPUTS AND COMMANDS ).
- Check for DTCs by selecting the TEST MODE menu from the HDS.
Are any DTCs indicated?
YES -Go to B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
NO -Go to step 2.
- Turn off the switch that controls the malfunctioning component.
- Select DATA LIST from the TEST MODE menu, and check the input of the switch that controls the component.
Does the HDS indicate the switch is OFF?
YES -Go to step 4.
NO -Go to 6.
- In the DATA LIST, check the output signal of the malfunctioning component.
Is the output signal OFF?
YES -Go to step 5.
NO -Replace the control unit that controls the device that will not turn OFF.
- Test the relay, that controls the device that does not stop or turn off, if applicable. If the relay tests OK, then check for a short in the wire between the relay and the component, the relay and control unit, or the component and control unit.
Are the relay and the wire harness OK?
YES -Replace the control unit that controls the component that will not turn OFF.
NO -Replace the relay or repair the wire harness.
- Test the switch, then check for a short in the wire between the switch and the control unit that monitors the switch.
Are the switch and wire harness OK?
YES -Replace the control unit that monitors the switch.
NO -Replace the switch or repair the wire harness.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.