SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEVAP SYSTEMEVAP CANISTER REPLACEMENT
2009 Honda CR-V EX, 2.4 RE3

EVAP Canister Replacement

2009 Honda CR-V EX, 2.4 RE3SECTION EVAP Canister Replacement
  1. Raise the vehicle on a lift.
  2. Remove the cover (A).
    Fig 1: Identifying Cover With Mounting Screws
    G06610191Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the EVAP canister baffle cover (A).
    Fig 2: EVAP Canister Baffle Cover With Mounting Screws With Torque Specification
    G06610192Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the hoses (A) and the fuel subharness 6P connector (B).
    Fig 3: Hoses And Fuel Subharness 6P Connector With Torque Specification
    G06610193Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the bolts (C) and the EVAP canister bracket (D).
  6. Remove the EVAP canister (A) from the EVAP canister bracket (B).
    Fig 4: EVAP Canister And EVAP Canister Bracket With Torque Specification
    G06610194Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the cap (A).
    Fig 5: Removing EVAP Canister Vent Shut Valve
    G06610195Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the EVAP canister vent shut valve (B).
  9. Install the EVAP canister vent shut valve into the new EVAP canister with new O-rings (C).
    NOTE: Do not coat the O-rings with oil.
  10. Install the parts in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.