Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSREAR SUSPENSIONUPPER ARM REPLACEMENT
2009 Honda CR-V EX, 2.4 RE3
Upper Arm Replacement
2009 Honda CR-V EX, 2.4 RE3SECTION Upper Arm Replacement
- Raise and support the vehicle (see LIFT AND SUPPORT POINTS ).
- Remove the rear wheel.
- Place a floor jack under the trailing arm, and support the suspension.
- Remove the wheel speed sensor harness bracket (A) from the upper arm (B).
- Remove the flange bolts (A), and remove the upper arm (B).NOTE: During installation, install new flange bolts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.