SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2008ODYSSEY EXREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISEVAP SYSTEMEVAP CANISTER REPLACEMENT
2008 Honda Odyssey EX

EVAP Canister Replacement

2008 Honda Odyssey EXSECTION EVAP Canister Replacement
  1. Raise the vehicle on a lift.
  2. Remove the EVAP canister cover (A).
    Fig 1: EVAP Canister Cover With Torque Specification
    G05524215Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the hoses (A), the FTP sensor 3P connector (B), and the EVAP canister vent shut valve 2P connector (C).
    Fig 2: EVAP Canister Assembly With Torque Specification
    G05524216Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts (D).
  5. Remove the EVAP canister assembly (E).
  6. Remove the EVAP canister bracket (A).
    NOTE: The canister filter remains on the bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.