Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adding multiple remote transmitters
Turn the ignition switch to ON (II), push the transmitter's lock or unlock button within 4 seconds and turn the ignition switch to LOCK (0), turn it back to ON (II) within 4 seconds and back to LOCK (0). Repeat this 2 more times and the locks should cycle when the transmitter button is pushed. Push the lock or unlock button on each remote to be programmed within 4 seconds of each other. Turn the ignition switch to LOCK (0) and remove the key. Wait 10 seconds and verify that all remotes being programmed are functioning properly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.