Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2008CIVIC SI, 4D SEDANREPAIR AND DIAGNOSISELECTRICALGAUGESDISPLAY AND GAUGE SYSTEM (EXCEPT HYBRID)GAUGE CONTROL MODULE REPLACEMENTTACHOMETER
2008 Honda Civic Si, 4D Sedan
Gauge Control Module Replacement: Tachometer
2008 Honda Civic Si, 4D SedanSECTION Tachometer
- Remove the subdisplay visor assembly (see SUBDISPLAY VISOR REMOVAL/INSTALLATION ).
- Remove the three screws from the gauge control module (tach) (A).
- Disconnect the 36P connector (B) from the gauge control module (tach).
- Install the gauge in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.