Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Manual Initialization
2007 Honda Ridgeline RTSSECTION Manual Initialization
- Start the engine (the VTM-4 indicator comes on, and the VTM-4 lock switch indicator is off).
- Apply the brakes, and move the shift lever to either R, 1, or 2, then push the VTM-4 lock switch (the VTM-4 indicator stays on, and the VTM-4 lock switch indicator is on). The 4WD system is now in lock mode.
- Turn the ignition switch off.
- Turn the ignition switch ON (II) (the VTM-4 indicator and the VTM-4 lock indicator both come on for 4 seconds, then go off). The VTM-4 control unit is initialized.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.