Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2007RIDGELINE RTSREPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DIFFERENTIALBACKLASH INSPECTION
2007 Honda Ridgeline RTS
Backlash Inspection
2007 Honda Ridgeline RTSSECTION Backlash Inspection
NOTE:
Connecting battery voltage to either the right or left clutch electromagnetic coils for more than 3 minutes will damage the rear differential.
- Install the left rear driveshaft, then connect the battery power to the No. 1 terminal of the left clutch electromagnetic coil 2P connector (A) and ground to the No. 2 terminal.
- Check the backlash of the companion flange (B) with a dial indicator (C).
Standard 1.23-2.38 mm (0.048-0.094 in.)
- If the backlash is out of standard, replace the rear differential.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.