Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2007RIDGELINE RTSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEMXM RECEIVER REMOVAL/INSTALLATION
2007 Honda Ridgeline RTS
XM Receiver Removal/Installation
2007 Honda Ridgeline RTSSECTION XM Receiver Removal/Installation
- Remove the rear panel insulator (see REAR PANEL INSULATOR REPLACEMENT ).
- Disconnect the antenna 2P connector (A) and 14P connector (B) from the XM receiver (C).
- Remove the three nuts, and remove the XM receiver.
- Install the XM receiver the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.