Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2007RIDGELINE RTSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEM COMPONENTSDTC TROUBLESHOOTING INDEX
2007 Honda Ridgeline RTS
DTC Troubleshooting Index
2007 Honda Ridgeline RTSSECTION DTC Troubleshooting Index
DTC TROUBLESHOOTING CHART
| DTC | Detection Item | ABS Indicator | Brake System Indicator | VSA Indicator | VSA Activation Indicator | ||
|---|---|---|---|---|---|---|---|
| 11 | Right-front wheel sensor (open/short to body ground/short to power) | ON | ON or OFF(1) | ON | ON | ||
| 12 | Right-front wheel sensor (electrical noise/intermittent interruption) | ON | ON or OFF(1) | ON | ON | ||
| 13 | Left-front wheel sensor (open/short to body ground/short to power) | ON | ON or OFF(1) | ON | ON | ||
| 14 | Left-front wheel sensor (electrical noise/intermittent interruption) | ON | ON or OFF(1) | ON | ON | ||
| 15 | Right-rear wheel sensor (open/short to body ground/short to power) | ON | ON or OFF(1) | ON | ON | ||
| 16 | Right-rear wheel sensor (electrical noise/intermittent interruption) | ON | ON or OFF(1) | ON | ON | ||
| 17 | Left-rear wheel sensor (open/short to body ground/short to power) | ON | ON or OFF(1) | ON | ON | ||
| 18 | Left-rear wheel sensor (electrical noise/intermittent interruption) | ON | ON or OFF(1) | ON | ON | ||
| 21 | Difference in wheel speed | ON | OFF | ON | ON | ||
| 22 | Current flow into wheel sensor input amplifier | OFF | ON | ON | ON | ||
| 25 | Yaw rate sensor (sensor unit) | OFF _, | OFF | ON | ON | ||
| 26 | Lateral acceleration sensor (sensor unit) | OFF | OFF | ON | ON | ||
| 27 | Steering angle sensor (hardware) | OFF | OFF | ON | ON | ||
| 31 | ABS solenoid | ON | ON | ON | ON | ||
| 32 | ABS solenoid | ON | ON | ON | ON | ||
| 33 | ABS solenoid | ON | ON | ON | ON | ||
| 34 | ABS solenoid | ON | ON | ON | ON | ||
| 35 | ABS solenoid | ON | ON | ON | ON | ||
| 36 | ABS solenoid | ON | ON | ON | ON | ||
| 37 | ABS solenoid | ON | ON | ON | ON | ||
| 38 | ABS solenoid | ON | ON | ON | ON | ||
| 45 | VSA solenoid | ON | ON | ON | ON | ||
| 46 | VSA solenoid | ON | ON | ON | ON | ||
| 47 | VSA solenoid | ON | ON | ON | ON | ||
| 48 | VSA solenoid | ON | ON | ON | ON | ||
| 51 | Motor Locked | ON | OFF | ON | ON | ||
| 52 | Motor stuck OFF | ON | OFF | ON | ON | ||
| 53 | Motor stuck ON | ON | OFF | ON | ON | ||
| 54 | Valve relay | ON | OFF | ON | |||
| 61 | IG1 voltage low | ON | OFF | ON | ON | ||
| 62 | IG1 voltage high | ON | ON | ON | ON | ||
| 65 | VSA pressure sensor (hardware) | ON | OFF | ON | ON | ||
| 66 | VSA pressure sensor (software) | ON | OFF | ON | ON | ||
| 67 | Brake pedal position switch (hardware) | OFF | OFF | ON | ON | ||
| 68 | Brake pedal position switch (software) | OFF | OFF | ON | ON | ||
| 72 | Steering angle sensor | OFF | OFF | ON | ON | ||
| 73 | Yaw rate sensor (power supply) | OFF | OFF | ON | ON | ||
| 74 | Yaw rate sensor (software) | OFF | OFF | ON | ON | ||
| 75 | Lateral acceleration sensor (joint failure) | OFF | OFF | ON | ON | ||
| 76 | Lateral acceleration sensor (software) | OFF | OFF | ON | ON | ||
| 81 | Central Processing Unit (CPU) | ON | OFF | ON | ON | ||
| 84 | Steering angle sensor No center point writing | OFF | OFF | ON | ON | ||
| 91 | F-CAN communication | OFF | OFF | ON | ON | ||
| 92 | F-CAN system | OFF | OFF | ON | ON | ||
| 97 | VSA system | OFF | OFF | ON | ON | ||
|
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.