SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006RIDGELINE RTLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (HEATING/AIR CONDITIONING)A/C CONDENSER REPLACEMENT
2006 Honda Ridgeline RTL

A/C Condenser Replacement

2006 Honda Ridgeline RTLSECTION A/C Condenser Replacement
WARNING: This page is about a different car, the 2008 Honda Pilot, 2007 Honda Pilot, and 2006 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant with a recovery/recycling/charging station (see REFRIGERANT RECOVERY  ).
  2. Remove the front bulkhead cover, and the hood latch (see HOOD RELEASE HANDLE REPLACEMENT ).
  3. Remove the bolts and the radiator upper brackets.
    Fig 1: Removing Radiator Upper Brackets With Bolts With Torque Specifications
    G04246900Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts and screw, then disconnect the discharge line (A) and receiver line (B) from the A/C condenser. Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
    Fig 2: Disconnecting Discharge Line And Receiver Line From A/C Condenser With Torque Specifications
    G04246901Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the bolts, then remove the A/C condenser by lifting it up. Be careful not to damage the radiator or the A/C condenser fins when removing the A/C condenser.
    Fig 3: Removing A/C Condenser With Bolts With Torque Specifications
    G04246902Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the A/C condenser in the reverse order of removal, and note these items:
    • If you're installing a new A/C condenser, add refrigerant oil (DENSO ND-OIL 8) (see A/C SERVICE TIPS AND PRECAUTIONS  ).
    • Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
    • Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
    • Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
    • Be careful not to damage the radiator or the A/C condenser fins when installing the A/C condenser.
    • Charge the system (see SYSTEM CHARGING  ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.