Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006ELEMENT EX, 2.4 YH1, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLABS (ANTI-LOCK BRAKE SYSTEM)ABS MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATIONREMOVAL
2006 Honda Element EX, 2.4 YH1, Standard
ABS Modulator-Control Unit Removal and Installation: Removal
2006 Honda Element EX, 2.4 YH1, StandardSECTION Removal
- Push in the locking tab (A) and pull up the lock (B) of the ABS modulator-control unit 47P connector (C), and the connector disconnects itself.
- Disconnect the six brake lines.
- Remove the ABS modulator-control unit (D) bracket (E) from the body.
- Remove the two 6 mm shoulder bolts (F) and 6 mm bolt (G) from the bracket, then remove the ABS modulator-control unit from the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.