Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2005ACCORD L4-2.4LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHTESTING AND INSPECTION
2005 Honda Accord L4-2.4L
Ignition Switch: Testing and Inspection
2005 Honda Accord L4-2.4LSECTION Testing and Inspection
Ignition Switch
Test
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Connect the HDS to the date link connector (DLC), and ground the SCS.
3. Disconnect the battery negative cable.
4. Remove the left front door sill trim and left kick panel.
5. Disconnect the 6P connector from the driver's under-dash fuse/relay box.
6. Check for continuity between the terminals in each switch position according to the table.
7. If the continuity checks do not agree with the table, replace the steering lock.
8. After reconnecting the battery, enter the anti-theft code for the radio and the navigation system, then enter the customer's radio station presets.
9. Do the power window control unit reset procedure.
Test
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
2. Connect the HDS to the date link connector (DLC), and ground the SCS.
3. Disconnect the battery negative cable.
4. Remove the left front door sill trim and left kick panel.
5. Disconnect the 6P connector from the driver's under-dash fuse/relay box.
6. Check for continuity between the terminals in each switch position according to the table.
7. If the continuity checks do not agree with the table, replace the steering lock.
8. After reconnecting the battery, enter the anti-theft code for the radio and the navigation system, then enter the customer's radio station presets.
9. Do the power window control unit reset procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.