Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2005ACCORD L4-2.4LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
2005 Honda Accord L4-2.4L
Connecting Rod Bearing
2005 Honda Accord L4-2.4LSECTION Connecting Rod Bearing
Rod Bearing Cap
Tighten the connecting rod bolts to 20 Nm (2.0 kgf-m, 14 ft. lbs.).
Tighten the connecting rod bolts an additional 90°.
Connecting Rod Bearing Clearance
Pin-to-rod clearance
Standard or New 0.005 - 0.015 mm (0.0002 - 0.0006 inch)
Service Limit 0.02 mm (0.0008 inch)
Tighten the connecting rod bolts to 20 Nm (2.0 kgf-m, 14 ft. lbs.).
Tighten the connecting rod bolts an additional 90°.
Connecting Rod Bearing Clearance
Pin-to-rod clearance
Standard or New 0.005 - 0.015 mm (0.0002 - 0.0006 inch)
Service Limit 0.02 mm (0.0008 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.