Cruise Control Servo: Service and Repair

2005 Honda Accord L4-2.4LSECTION Service and Repair
Cruise Control Actuator/Cable Replacement




1. Loosen the locknut (A), then remove the cruise control cable (B) from the throttle linkage.




2. Disconnect the 4P connector (A), and remove the actuator cover (B), then remove the bolts securing the actuator.




3. Remove the actuator cable from the actuator.
4. Install in the reverse order of removal, and adjust the free play at the throttle linkage after connecting the cruise control cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.