Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2004S2000 L4-2.2LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER SWITCHSERVICE AND REPAIR
2004 Honda S2000 L4-2.2L
Wiper Switch: Service and Repair
2004 Honda S2000 L4-2.2LSECTION Service and Repair
Wiper/Washer Switch Test/Replacement
1. Lower the steering column, and remove the steering column covers.
2. Disconnect the 14P connector from the wiper/washer switch.
3. Remove the two screws, then pull out the wiper/washer switch.
4. Check for continuity between the terminals in each switch position according to the table. If the continuity is not as specified, replace the switch.
1. Lower the steering column, and remove the steering column covers.
2. Disconnect the 14P connector from the wiper/washer switch.
3. Remove the two screws, then pull out the wiper/washer switch.
4. Check for continuity between the terminals in each switch position according to the table. If the continuity is not as specified, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.