SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2002INSIGHT STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSSRS (SUPPLEMENTAL RESTRAINT SYSTEM)PRECAUTIONS AND PROCEDURESDISCONNECTING SYSTEM CONNECTORSDRIVER'S AIRBAG
2002 Honda Insight Standard

Driver's Airbag

2002 Honda Insight StandardSECTION Driver's Airbag
  1. 2. Remove the access panel from the steering wheel, then disconnect the driver's airbag 2P connector (A) from the cable reel.
    Fig 1: Disconnecting Driver's Airbag 2P Connector From Cable Reel
    G03683087Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.