Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2002INSIGHT STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSEXTERIORSHEADLIGHT REPLACEMENTHEADLIGHT BULB REPLACEMENT

2002 Honda Insight Standard

Headlight Bulb Replacement

2002 Honda Insight StandardSECTION Headlight Bulb Replacement

Disconnect the 3P connector (A) from the headlight.
HEADLIGHT: 60/55 W

FRONT PARKING LIGHT: 5 W

FRONT SIDE MARKER LIGHT: 5 W

Fig 1: Disconnecting 3P Connector From Headlight
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the retainer (B) and bulb (C).
Disconnect the 2P connectors, then turn the bulb socket 45° counterclockwise to remove the bulb.
Remove the inner fender (see FRONT INNER FENDER REPLACEMENT ).
Disconnect the 2P connector (A), then turn the bulb socket 45° counterclockwise to remove the bulb (B).
FRONT TURN SIGNAL LIGHT: 21 W

Fig 2: Disconnecting 2P Connector And Removing Bulb Socket
Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.