Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2001ODYSSEY LXREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTING SYSTEMON-VEHICLE TESTINGIGNITION SWITCH TESTS2000

2001 Honda Odyssey LX

Ignition Switch Test: S2000

2001 Honda Odyssey LXSECTION S2000

Disconnect negative battery cable. Disconnect 7-pin connector from steering column harness. Using an ohmmeter, check continuity between specified connector terminals, with ignition switch in appropriate position. See Fig 1 and Fig 2 . If continuity is not as specified, replace ignition switch.

Fig 1: Testing Ignition Switch Continuity (S2000)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.