2000 Honda InsightFACTORY OEM SERVICE PROCEDURE

ABS Modulator-Control Unit Removal and Installation: Installation

  1. Install the ABS modulator-control unit on the bracket, then tighten the two 6 mm nuts.
  2. Connect the six brake lines to the ABS modulator-control unit, and tighten the flare nuts to the specified torque.
  3. Align the connecting surface of the ABS modulator-control unit 25P connector.
  4. Push in the lock of the ABS modulator-control unit 25P connector until you hear it click into place, then connect the connector.
  5. Bleed the brake system, starting with the front wheels (see BRAKE SYSTEM BLEEDING ).
  6. Start the engine, and check that the ABS indicator goes off.
  7. Test-drive the vehicle, check the ABS operation, and check that the ABS indicator does not come on.
  8. If the brake pedal is now spongy, there may be air trapped in the modulator and then induced into the normal brake system during modulation. Bleed the brake system again, starting with the front wheels (see BRAKE SYSTEM BLEEDING ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.