Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 10 (Cruise Control System): Description
The cruise control system uses mechanical, electrical and vacuum operated devices to maintain selected vehicle speed at more than 25 MPH. The cruise control unit receives command signals from cruise control main switch and cruise control SET/RESUME switch. It also receives operating signals from brakelight switch, ignition coil, speed sensor, clutch switch (M/T) or shift position switch (A/T).
The cruise control unit compares actual vehicle speed to selected speed. The brakelight switch releases system control of throttle when brake pedal is pressed. The clutch switch, shift position switch and cancel switch sends a disengage signal to the cruise control unit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.