Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1994PRELUDE S, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSDOOR LOCKS & TAILGATE RELEASE - POWERTRANSMITTER PROGRAMMING
1994 Honda Prelude S, Standard
Transmitter Programming
1994 Honda Prelude S, StandardSECTION Transmitter Programming
- Open driver's door. Press and hold driver's master power door lock switch in the UNLOCK position.
- Within 10 seconds, insert and remove key from ignition switch 5 times. On the sixth key insertion, leave key in ignition switch. All doors should unlock, indicating system is now in programming mode.
- Release driver's master door lock switch. Press either button on the transmitter. All doors except driver's door will lock and unlock indicating system has accepted transmitter into its memory. If either transmitter button is pressed again, all doors will lock and unlock.
- To program a second transmitter, press either button on that transmitter. The door will lock and unlock indicating that the second transmitter has been accepted into accepted into the system memory.
- To exit the programming mode, close driver's door and remove key from ignition switch. Check door lock operation at both front door locks. If door locks door not function properly, repeat programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.