Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1993ACCORD L4-2156CC 2.2L SOHCREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYPISTON RING, ENGINE
1993 Honda Accord L4-2156cc 2.2L SOHC
Piston Ring, Engine
1993 Honda Accord L4-2156cc 2.2L SOHCSECTION Piston Ring, Engine
COMPONENT UNIT: mm (in)
PISTON TO RING CLEARANCE, TOP
Standard (New) 0.035 - 0.060 (0.0014 - 0.0024)
Service Limit 0.13 (0.005)
PISTON TO RING CLEARANCE, SECOND
Standard (New) 0.030 - 0.055 (0.0012 - 0.0022)
Service Limit 0.13 (0.005)
RING END GAP, TOP
Standard (New) 0.20 - 0.35 (0.008 - 0.014)
Service Limit 0.60 (0.024)
RING END GAP, SECOND
Standard (New) 0.40 - 0.55 (0.016 - 0.022)
Service Limit 0.70 (0.028)
RING END GAP, OIL
Standard (New) 0.20 - 0.70 (0.008 - 0.028)
Service Limit 0.80 (0.031)
PISTON TO RING CLEARANCE, TOP
Standard (New) 0.035 - 0.060 (0.0014 - 0.0024)
Service Limit 0.13 (0.005)
PISTON TO RING CLEARANCE, SECOND
Standard (New) 0.030 - 0.055 (0.0012 - 0.0022)
Service Limit 0.13 (0.005)
RING END GAP, TOP
Standard (New) 0.20 - 0.35 (0.008 - 0.014)
Service Limit 0.60 (0.024)
RING END GAP, SECOND
Standard (New) 0.40 - 0.55 (0.016 - 0.022)
Service Limit 0.70 (0.028)
RING END GAP, OIL
Standard (New) 0.20 - 0.70 (0.008 - 0.028)
Service Limit 0.80 (0.031)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.