Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1993ACCORD L4-2156CC 2.2L SOHCREPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - A/TTESTING AND INSPECTION
1993 Honda Accord L4-2156cc 2.2L SOHC
Fluid - A/T: Testing and Inspection
1993 Honda Accord L4-2156cc 2.2L SOHCSECTION Testing and Inspection
FLUID LEVEL CHECK
NOTE: Check the fluid level with the engine at normal operating temperature (the radiator fan comes on).
1. Park the vehicle on level ground. Turn off the engine.
2. Remove the dipstick (yellow loop) from the transmission, and wipe it with a clean cloth.
3. Insert the dipstick into the transmission.
4. Remove the dipstick and check the fluid level. It should be between the upper and lower marks.
5. If the level is below the lower mark, pour the recommended fluid* into the dipstick tube to bring it to the upper mark.
6. Insert the dipstick back into the transmission.
NOTE: Check the fluid level with the engine at normal operating temperature (the radiator fan comes on).
1. Park the vehicle on level ground. Turn off the engine.
2. Remove the dipstick (yellow loop) from the transmission, and wipe it with a clean cloth.
3. Insert the dipstick into the transmission.
4. Remove the dipstick and check the fluid level. It should be between the upper and lower marks.
5. If the level is below the lower mark, pour the recommended fluid* into the dipstick tube to bring it to the upper mark.
6. Insert the dipstick back into the transmission.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.