Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1993ACCORD L4-2156CC 2.2L SOHCREPAIR AND DIAGNOSISMAINTENANCEFLUIDSENGINE OILSERVICE AND REPAIR
1993 Honda Accord L4-2156cc 2.2L SOHC
Engine Oil: Service and Repair
1993 Honda Accord L4-2156cc 2.2L SOHCSECTION Service and Repair
CAUTION: Remove the drain plug carefully while the engine is hot, the hot oil may cause scalding.
NOTE: The oil filter should be replaced at each oil change.
1. Warm up the engine.
2. Drain the engine oil.
3. Reinstall the drain plug with a new washer, and refill with the recommended oil for the recommended temperature.
Requirement:
API Service Grade: Use "Energy Conserving II" SG grade oil, 5W-30 preferred.
Capacity:
3.8 l (4.0 US qt, 3.3 Imp qt) at change, including filter.
4.9 l (5.2 US qt, 4.3 Imp qt) after engine overhaul.
Change:
Every 7,500 miles (12,000 km) or 6 months.
CAUTION: Do not overtighten the drain plug.
NOTE: The oil filter should be replaced at each oil change.
1. Warm up the engine.
2. Drain the engine oil.
Engine Oil Drain Plug:
Oil Viscosity Recommendations:
3. Reinstall the drain plug with a new washer, and refill with the recommended oil for the recommended temperature.
Requirement:
API Service Grade: Use "Energy Conserving II" SG grade oil, 5W-30 preferred.
Capacity:
3.8 l (4.0 US qt, 3.3 Imp qt) at change, including filter.
4.9 l (5.2 US qt, 4.3 Imp qt) after engine overhaul.
Change:
Every 7,500 miles (12,000 km) or 6 months.
CAUTION: Do not overtighten the drain plug.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.