Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1993ACCORD L4-2156CC 2.2L SOHCREPAIR AND DIAGNOSISMAINTENANCEDRIVE BELTSPECIFICATIONSALTERNATOR
1993 Honda Accord L4-2156cc 2.2L SOHC
Alternator
1993 Honda Accord L4-2156cc 2.2L SOHCSECTION Alternator
BELT DEFLECTION [1]
New Belt with A/C 4.5 - 7.0 mm (0.18 - 0.28 in)
New Belt w/o A/C 8.5 - 11.0 mm (0.33 - 0.43 in)
Used Belt 10.0 - 12.0 mm (0.39 - 0.47 in)
BELT TENSION, WITH A/C [2]
New Belt 950 - 1150 N (209 - 253 lbs)
Used Belt 450 - 600 N (99 - 132 lbs)
BELT TENSION, WITHOUT A/C [2]
New Belt 450 - 600 N (99 - 132 lbs)
Used Belt 350 - 450 N (66 - 99 lbs)
[1] As measured between pulleys with 22 lbs (10 Kg) of force. A used belt is defined as having been continuously run for five minutes.
[2] Using tension gauge.
New Belt with A/C 4.5 - 7.0 mm (0.18 - 0.28 in)
New Belt w/o A/C 8.5 - 11.0 mm (0.33 - 0.43 in)
Used Belt 10.0 - 12.0 mm (0.39 - 0.47 in)
BELT TENSION, WITH A/C [2]
New Belt 950 - 1150 N (209 - 253 lbs)
Used Belt 450 - 600 N (99 - 132 lbs)
BELT TENSION, WITHOUT A/C [2]
New Belt 450 - 600 N (99 - 132 lbs)
Used Belt 350 - 450 N (66 - 99 lbs)
[1] As measured between pulleys with 22 lbs (10 Kg) of force. A used belt is defined as having been continuously run for five minutes.
[2] Using tension gauge.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.