Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1983PRELUDE AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMTHROTTLE CONTROL SYSTEMCOMPONENT TESTINGCRANKING SOLENOID VALVE
1983 Honda Prelude Automatic
Cranking Solenoid Valve
1983 Honda Prelude AutomaticSECTION Cranking Solenoid Valve
NOTE:
Perform this test on hot engine. Test is for Accord and Civic only.
- Ground the coil secondary wire to prevent the engine from starting. Turn the ignition to "START" position. The throttle controller arm should retract when the engine is cranked. If the controller operates, the cranking solenoid valve is functional. Test is complete.
- If the controller does not operate, check for voltage at the cranking solenoid valve. Check at Control Box No. 1, Green wire on Civic. Check at connector Blue/Red wire on Accord. If no voltage is present, check wiring and fuse.
- On Accord, if there are no defects, replace the starter relay located on the relay bracket. On all models, if voltage is present, disconnect the hose between the cranking solenoid valve and and check valve at the solenoid valve. Check for vacuum when cranking engine.
- There should be vacuum with the ignition switch turned to "START" position. If there is vacuum, replace the cranking solenoid valve and retest. If there is no vacuum, check the vacuum line for leaks or blockage. If they are okay, replace the check valve and retest.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.