Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA1983PRELUDE AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESINSTRUMENT PANEL - STANDARDREMOVAL & INSTALLATIONCOMBINATION SWITCHREMOVAL
1983 Honda Prelude Automatic
Combination Switch: Removal
1983 Honda Prelude AutomaticSECTION Removal
Remove steering wheel. Pull turn signal cancel sleeve and washer off steering column. Remove column covers. Unplug wiring connectors and remove clamp screw. Remove combination switch.
NOTE:
Steering column can be lowered to improve access if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.