Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Accessory Power Relay | Behind Left KickPanel, Mounted To Relay Block Cassette |
| Audio Alarm Module | Behind Left Kick Panel, Mounted To |
| Junction Block No. 1 | Lower Left Shroud, Behind Kick Panel |
| Junction Block No. 3 | Behind Center Of Instrument Panel, In Junction Block Retainer |
| Junction Connector No. 1 (6-Pin) | Behind Center Of Instrument Panel, Mounted To Right Support Brace |
| Power Window Motor | In Respective Door, Behind Trim Panel Near Armrest |
| Power Window/Door Lock Switch | In Left Front Door, In Armrest |
| Power Window Switch | In Respective Door, In Or Near Armrest |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.