Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Geo Prizm Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Power Windows
- Description & Operation
- Component Locations
- Trouble Shooting
- Functional Test
- Symptom Tests
- Notes
- All Windows Do Not Operate With All Window Switches
- Left Front Window Does Not Open
- Left Front Window Does Not Close
- Right Front Window Does Not Open With Either Right Front Window Switch Depressed
- Right Front Window Does Not Close With Either Right Front Window Switch Pulled Up
- Left Rear Window Does Not Open With Either Left Rear Power Window Switch Depressed
- Left Rear Window Does Not Close With Either Left Rear Power Window Switch Pulled Up
- Right Rear Window Does Not Open With Either Right Rear Power Window Switch Depressed
- Right Rear Window Does Not Close With Either Right Rear Window Switch Pulled Up
- Window Does Not Operate From Left Front Power Window/Door Lock Switch Only
- Window Does Not Operate From Respective Power Window Switch Only
- All Windows Operate When Window Lock Switch Is Pressed To Lock Position
- Left Front Window Does Not Automatically Open Fully Using Auto Down Feature
- Windows Function With Ignition Switch In Lock Position
- Left Front Power Window/Door Lock Illumination Inoperative
- Removal & Installation
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.