Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Geo Metro Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Toe-In Adjustment (Front)
- Adjust front wheel toe-in by changing tie rod length. Loosen rack boot clamps (small end), and slide clamps from boot. Loosen right and left tie rod end lock nuts.
- Turn right and left tie rods same amount to adjust toe-in to specification. See ALIGNMENT SPECIFICATIONS . Tighten tie rod end nuts to specification. See TORQUE SPECIFICATIONS . Dimension "A" should be the same on left and right tie rods. See Fig 1.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.