Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Geo Metro Base, 2D HatchbackFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS (1)
| Application | Preferred | Range | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Camber (2) | |||||||||
| Front & Rear | 0 | -1.0 To 1.0 | |||||||
| Caster (2) | |||||||||
| Front | 3 | 2 To 4 | |||||||
| Toe-In (2) | |||||||||
| Front & Rear | 0.16 | 0 To 0.32 | |||||||
| Toe-In (3) | |||||||||
| Front & Rear | 0.08 (2.0) | 0 To 0.16 (0 To 4.0) | |||||||
| Toe-Out On Turns (2) | |||||||||
| Inner | 38 | N/A | |||||||
| Outer | 32 | N/A | |||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.