Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGEO1993PRIZM L4-1600CC 1.6L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIRSUB-OXYGEN SENSOR - CALIFORNIA ONLY
1993 Geo Prizm L4-1600cc 1.6L DOHC
Sub-Oxygen Sensor - California Only
1993 Geo Prizm L4-1600cc 1.6L DOHCSECTION Sub-Oxygen Sensor - California Only
SUB-OXYGEN SENSOR (SUB-02S) REPLACEMENT
Remove or Disconnect
1. Negative (-) battery cable.
^ Raise and support vehicle.
2. Sub-O2S electrical connector.
3. Two nuts and Sub-O2S from vehicle.
Install or Connect
1. Sub-O2S to vehicle; secure with two nuts.
Tighten
Sub-oxygen sensor nuts to 41 Nm (30 lb.ft.).
2. Sub-O2S electrical connector.
^ Lower vehicle.
3. Negative (-) battery cable.
Tighten
^ Negative (-) battery cable-to-negative(-) battery terminal retainer to 15 Nm (11 lb-ft).
Sub-Oxygen Sensor:
Remove or Disconnect
1. Negative (-) battery cable.
^ Raise and support vehicle.
2. Sub-O2S electrical connector.
3. Two nuts and Sub-O2S from vehicle.
Install or Connect
1. Sub-O2S to vehicle; secure with two nuts.
Tighten
Sub-oxygen sensor nuts to 41 Nm (30 lb.ft.).
2. Sub-O2S electrical connector.
^ Lower vehicle.
3. Negative (-) battery cable.
Tighten
^ Negative (-) battery cable-to-negative(-) battery terminal retainer to 15 Nm (11 lb-ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.