Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGEO1993PRIZM L4-1600CC 1.6L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORSERVICE AND REPAIROXYGEN (O2S) SENSOR REPLACEMENTCALIFORNIA
1993 Geo Prizm L4-1600cc 1.6L DOHC
California
1993 Geo Prizm L4-1600cc 1.6L DOHCSECTION California
Oxygen Sensor:
OXYGEN SENSOR (O2S) REPLACEMENT
Remove or Disconnect
1. Negative (-) battery cable.
2. O2S electrical connector.
3. Two nuts and 02S from vehicle.
Install or Connect
1. O2S to vehicle; secure with two nuts.
Tighten
^ O2S nuts to 41 Nm (30 lb.ft).
2. O2S electrical connector.
3. Negative (-) battery cable.
Tighten
^ Negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb.ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.