Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGEO1993PRIZM L4-1600CC 1.6L DOHCREPAIR AND DIAGNOSISMAINTENANCETECHNICAL SERVICE BULLETINSBY SYMPTOMIMPROPER ALIGNMENTWHEEL ALIGNMENT - REVISED SPECIFICATIONS
1993 Geo Prizm L4-1600cc 1.6L DOHC
Wheel Alignment - Revised Specifications
1993 Geo Prizm L4-1600cc 1.6L DOHCSECTION Wheel Alignment - Revised Specifications
Number: 93-245-3A
Section: 3A
Date: JUNE 1993
Corporate Bulletin No.: 333101
AM No.: A4
Subject:
WHEEL ALIGNMENT
Model and Year:
1993 GEO PRIZM
SERVICE UPDATE
The specifications contained in this service bulletin replace those found in Wheel Alignment (Section 3A) of the 1993 Geo Prizm Service Manual (ST373-93). Use the specifications in this bulletin whenever it becomes necessary to adjust the front and rear wheel alignment.
Section: 3A
Date: JUNE 1993
Corporate Bulletin No.: 333101
AM No.: A4
Subject:
WHEEL ALIGNMENT
Model and Year:
1993 GEO PRIZM
SERVICE UPDATE
The specifications contained in this service bulletin replace those found in Wheel Alignment (Section 3A) of the 1993 Geo Prizm Service Manual (ST373-93). Use the specifications in this bulletin whenever it becomes necessary to adjust the front and rear wheel alignment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.