Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Toe-In Adjustment: Metro
Adjust front wheel toe-in by changing tie rod length. Loosen right and left tie rod end lock nuts. Turn right and left tie rods by the same amount to adjust toe-in to specification. See appropriate table under WHEEL ALIGNMENT SPECIFICATIONS . Right and left tie rod length "A" should be the same. See Figure. Tighten tie rod end nuts to specification. See TORQUE SPECIFICATIONS .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.