Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIRBAG MODULES AND CLOCK SPRINGPASSENGER AIRBAG (PAB) MODULEREPAIR PROCEDURESINSTALLATION
2021 Genesis GV80 2.5T Advanced, AWD
Repair Procedures: Installation
2021 Genesis GV80 2.5T Advanced, AWDSECTION Installation
- Disconnect the negative (-) battery terminal.WARNING:
- Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
- Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque:
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
- Install the main crash pad assembly.
(Refer to Body (Interior and Exterior) - "MAIN CRASH PAD ASSEMBLY ")
- Connect the passenger airbag connector.
- Reconnect the battery negative (-) terminal.
- After installing the passenger airbag, confirm proper system operation.NOTE:
- Turn the ignition switch ON; the SRS indicator light should turn on for about 6 seconds and then go off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.