SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISELECTRICALGAUGESCRASH PADCRASH PAD CENTER PANELREPAIR PROCEDURESREPLACEMENTCRASH PAD CENTER PANEL (LH)
2021 Genesis GV80 2.5T Advanced, AWD

Crash Pad Center Panel (LH)

2021 Genesis GV80 2.5T Advanced, AWDSECTION Crash Pad Center Panel (LH)
CAUTION:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the floor console assembly.

    (Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")

  2. Remove the crash pad lower panel.

    (Refer to Crash Pad - "CRASH PAD LOWER PANEL ")

  3. Remove the crash pad side cover [RH].

    (Refer to Crash Pad - "CRASH PAD SIDE COVER ")

  4. Loosen the mounting screw, remove the crash pad center panel [RH] (A).
    G14723352Courtesy of HYUNDAI MOTOR AMERICA
  5. Press the lock pin, separate the start button connector (A).
    G14723353Courtesy of HYUNDAI MOTOR AMERICA
  6. Loosen the mounting screws and nut, remove the crash pad center panel garnish (A).
    G14723354Courtesy of HYUNDAI MOTOR AMERICA
  7. Loosen the mounting screws and nut, remove the crash pad center panel [LH] (A).
    G14723355Courtesy of HYUNDAI MOTOR AMERICA
  8. Separate the in-car sensor connector (A) and crash pad mood lamp connector (B).
    G14723356Courtesy of HYUNDAI MOTOR AMERICA
  9. To install, reverse removal procedure.

    Information 

    • Replace any damaged clips (or pin-type retainers).
    • Make sure the connector are connected in properly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.