Terminal Tightening State Inspection

2021 Genesis GV80 2.5T Advanced, AWDSECTION Terminal Tightening State Inspection
NOTE:
  • Alternator B+ terminal state
  • Alternator B+ terminal tightening nut
  • Battery positive (+) terminal state
  • Battery positive (+) terminal tightening nut state
  • Battery negative (-) terminal state
  • Battery negative (-) terminal tightening nut state
  • Battery negative (-) terminal mounting bolt tightening state (Chassis ground)
  • Battery sensor negative (-) terminal state (With battery sensor)
  • Battery sensor negative (-) terminal tightening nut state (With battery sensor)
  • Battery sensor negative (-) terminal mounting bolt tightening state (Chassis ground) [With battery sensor]
  • Engine room fuse & relay box positive (+) harness state
  • Engine room fuse & relay box positive (+) harness tightening nut state
  • Check the status of ground fault by chassis paint
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.