SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSCHARGING SYSTEM - 2.5LBATTERY SENSORREPAIR PROCEDURESREMOVAL & INSTALLATION
2021 Genesis GV80 2.5T Advanced, AWD

Removal & Installation

2021 Genesis GV80 2.5T Advanced, AWDSECTION Removal & Installation
  1. Turn the ignition switch OFF.
  2. Remove the battery.

    (Engine Electrical System - "Battery")

  3. Disconnect the battery sensor connector (A).
  4. Remove the battery sensor cable after loosening the battery sensor cable mounting bolt (A).

    Tightening torque: 

    27.4 - 33.3 N.m (2.8 - 3.4 kgf.m, 20.2 - 24.5 lb-ft)

    G14721215Courtesy of HYUNDAI MOTOR AMERICA
  5. Install in the reverse order of removal.
    NOTE:
    • If the vehicle's parasitic current is consumed by more than 100 mA, abnormal signals from the battery sensors may be present, so if any abnormal signals from the battery sensors are emitted, perform a parasitic current inspection before proceeding with the replacement procedure of the battery sensors.
    • If the parasitic current inspection is normal, perform the below procedures after replace the battery sensor.
    1. Turn the ignition switch ON/OFF once, and then parking vehicle more than 4 hr at the room temperature.

      (Battery stability is required to measure the SOC initial value of the battery in the battery sensor)

    2. After 4 hours, check the SOC (State of charge) of the battery using the diagnosis tool.
    3. Start the engine ON and OFF more than twice, check the SOF (State of function) of the battery using the diagnosis tool.
      • If the vehicle with the battery sensor, note the below when replacing or charging the battery to prevent damage to the performance of the battery sensor.
    1. Note that replace the battery with the same specifications (capacity, manufacturer, etc.)
    2. Note that install the battery negative (-) terminal with the specified torques. If the over torque, PCB internal circuit and battery terminal can damage.
    3. When the battery charging, ground the negative (-) terminal to the chassis.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.