Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXELECTRONIC LIMITED SLIP DIFFERENTIAL DTCS
2021 Genesis GV80 2.5T Advanced, AWD
Electronic Limited Slip Differential DTCS
2021 Genesis GV80 2.5T Advanced, AWDSECTION Electronic Limited Slip Differential DTCS
ELECTRONIC LIMITED SLIP DIFFERENTIAL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0606-41 | ECM/PCM Processor |
| P0606-47 | ECM/PCM Processor |
| P0606-49 | ECM/PCM Processor |
| P1881-16 | Battery Voltage Low |
| P1882-11 | Motor Wire Short To Ground |
| P1882-12 | Motor Wire Short To Battery |
| P1882-13 | Motor Wire Open |
| P1885-11 | Pressure Sensor Supply Voltage Low |
| P1885-12 | Pressure Sensor Supply Voltage High |
| P1887-11 | Pressure Sensor Signal Voltage Low |
| P1887-12 | Pressure Sensor Signal Voltage High |
| P1889-00 | Clutch Torque Tolerance Upper Limit |
| P1890-00 | Clutch Torque Tolerance Lower Limit |
| P1896-00 | Bleed Pressure Line Test Error |
| P1898-00 | Front/Rear Tire Difference Too Big Or All Wheel Information Missing |
| U0001-88 | CAN Communication Bus Off |
| U0100-87 | Lost Communication With ECM/PCM |
| U0101-87 | Lost Communication With TCM |
| U0122-87 | Lost Communication With Vehicle Dynamics Control Module |
| U0124-87 | Lost Communication With ACU |
| U0126-87 | Lost Communication With Steering Angle Sensor Module |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.