Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSPOWER TAILGATE MODULEINSPECTIONPOWER TAILGATE NG LIST
2021 Genesis GV80 2.5T Advanced, AWD
Power Tailgate NG List
2021 Genesis GV80 2.5T Advanced, AWDSECTION Power Tailgate NG List
| List | Solution |
|---|---|
| CAN BUS OFF | Check CAN Line |
| Power Tailgate Module Inline Mode Not Deactivated | 1. S/W Management - Disable Inline Mode |
| 2. Disable inline mode by driving (5 km/hf) | |
| PTG Unlatch Error | 1. Check latch connector plugged in properly |
| 2. Check latch wiring | |
| 3. Check latch assembly | |
| PTG Spindle Hall Sensor Error, LH | 1. Check spindle connector plugged in properly - LH |
| 2. Check spindle wiring - LH | |
| 3. Check spindle assembly - LH | |
| PTG Spindle Hall Sensor Error, RH | 1. Check spindle connector plugged in properly - RH |
| 2. Check spindle wiring - RH | |
| 3. Check spindle assembly - RH | |
| PTG Anti-Pinch Sensor Error, LH | 1. Check anti-pinch sensor connector plugged in properly - LH |
| 2. Check anti-pinch sensor wiring - LH | |
| 3. Check anti-pinch sensor assembly - LH | |
| PTG Anti-Pinch Sensor Error, RH | 1. Check anti-pinch sensor connector plugged in properly - RH |
| 2. Check anti-pinch sensor wiring - RH | |
| 3. Check anti-pinch sensor assembly - RH | |
| PTG Latch Cinching Rewinding Fail Max | 1. Check latch connector plugged in properly |
| 2. Check latch wiring | |
| 3. Check latch assembly | |
| PTG Integrated Latch Home Position Switch Error | 1. Check latch connector plugged in properly |
| 2. Check latch wiring | |
| 3. Check latch internal switch signal | |
| 4. Check latch assembly | |
| PTG Integrated Latch Switch Combination Error | 1. Check latch connector plugged in properly |
| 2. Check latch wiring | |
| 3. Check latch internal switch signal | |
| 4. Check latch assembly |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.