Power Tailgate Opening

2021 Genesis GV80 2.5T Advanced, AWDSECTION Power Tailgate Opening
G14724090Courtesy of HYUNDAI MOTOR AMERICA

** - Primary switch signal received by PTGM via CAN bus (sent by SJB)

PTGM Opening procedure:Β 

  1. Opening can be triggered after a signal is received from, driver-console switch, outside handle switch, remote Key (FOB)
  2. The latch will be released (by SJB) by actuation of latch motor.
  3. On latch release, the tailgate latch pops out of the striker.
  4. PTG module controls the tailgate motor in order to open the tailgate.
  5. The rotating speed of the tailgate motor can be hall sensor that is built in the motor.
  6. Opening angle of the tailgate is calculated by counting the input pulse signals from Hall sensor.
    NOTE: When the motor movement is restricted, the PTGM stops the tailgate motor movement due to obstacle detection.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.