Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021GV80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSPOWER TAILGATE MODULEDESCRIPTION & OPERATIONOPERATIONBUZZER OPERATION
2021 Genesis GV80 2.5T Advanced, AWD
Buzzer Operation
2021 Genesis GV80 2.5T Advanced, AWDSECTION Buzzer Operation
Buzzer operation is defined in the following chart.
| Operation | BUZZER | LAMP(1) | Remark | ||
|---|---|---|---|---|---|
| T/gate start | 2 times | 2 times | When T/gate is triggered by Remote Contol or T/gate Console Switch | ||
| T/gate start | n.a. | n.a. | When T/gate is triggered by T/gate Inner Switch or T/gate Outer Handle Switch | ||
| T/gate stop | n.a. | n.a. | |||
| System error | 3 Times | PCU/Tailgate antiplay active, 0ver-/undervoltage condition, Endposition-/position error, spindle error, CAN error, Latch closed when Tailgate open | |||
| T/gate not closed | 10 times | 10 times | Latch Lock Switch not present | ||
| During Calibration run | Continuous ON-OFF beeping | n.a. | Activate buzzer but not C_PT Hazard | ||
| Max. End Position learned | n.a. | 2 times | Buzzer confirms learning finished | ||
| Max. End Position deleted | 1 time | n.a. | Buzzer confirms "position deleted" | ||
| Car is moving with open T/gate | 10 times | n.a. | T/gate open AND Speed >3 km/h | ||
| Garage Position saved | 2 times | n.a. | Buzzer confirms "New Garage Position" | ||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.