Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021G80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISELECTRICALGAUGESCRASH PAD ASSEMBLYGLOVE BOXREPAIR PROCEDURESREPLACEMENT
2021 Genesis G80 2.5T Advanced, AWD
Repair Procedures: Replacement
2021 Genesis G80 2.5T Advanced, AWDSECTION Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Take care not to bend or scratch the trim and panels.
- Open the glove box (A).
- Using a remover, remove the lock pin and then remove the air damper (A).
- Pull out the both sides stopper (A) from the glove box.
- Remove the lock pins (A) and then remove the glove box (B).
- Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.