Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2021G80 2.5T ADVANCED, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER TRUNK MODULE DIAGNOSISDTC B24D0-00: POWER TRUNK MODULE INLINE MODE NOT DEACTIVATEDDTC INFORMATION AND INSPECTIONMONITOR DTC STATUS
2021 Genesis G80 2.5T Advanced, AWD
Monitor DTC Status
2021 Genesis G80 2.5T Advanced, AWDSECTION Monitor DTC Status
- Connect GDS and select the "DTC Analysis" mode.
- Click the "DTC Status" to check the DTC information.
- Read the "DTC Status" parameter, and Record all DTCs, DTC state and freeze frame data.
- Is the DTC active?
YES
- Perform the "S/W Management" → "Option Treatment" → [Change Power Tailgate Mode] with GDS and change the operating mode to "Field Mode".
NO
- This can occur when the PTL*'s memory is not cleared after the repair.
→ Go to the "Verification of Repair" procedure.
| Component | Name_ETM | ETM |
|---|---|---|
| PTL* | "PTL UNIT" | SD817-1 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.