SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2020G90 3.3T PREMIUM, AWDREPAIR AND DIAGNOSISENGINE MECHANICALLUBRICATION SYSTEM - 3.3LOIL PANREPAIR PROCEDURESINSTALLATION[LOWER OIL PAN]
2020 Genesis G90 3.3T Premium, AWD

[Lower oil pan]

2020 Genesis G90 3.3T Premium, AWDSECTION [Lower oil pan]
  1. Install the lower oil pan (A).
    1. Using a gasket scraper, remove all the old packing material from the gasket surfaces.
    2. Before assembling the oil pan, the liquid sealant THREE BOND 1217H should be applied on oil pan. The assembly must be done within 5 minutes after the sealant is applied.

      Bead width:  2.5 mm (0.1 in.)

      [2WD] 

      G13547199Courtesy of HYUNDAI MOTOR AMERICA

      [AWD] 

      G13547200Courtesy of HYUNDAI MOTOR AMERICA
      NOTE:
      • Clean the sealing face before assembling two parts.
      • Remove harmful foreign matters on the sealing face before applying sealant.
      • When applying sealant gasket, sealant must not protrude into the inside of oil pan.
      • To prevent leakage of oil, apply sealant gasket to the inner threads of the bolt holes.
      • After assembly, wait at least 30 minutes before filling the engine with oil.
    3. Install the oil pan (A).

      Tighten the bolts in two or three steps.

    [2WD] 

    G13547201Courtesy of HYUNDAI MOTOR AMERICA

    [AWD] 

    G13547202Courtesy of HYUNDAI MOTOR AMERICA
  2. After assembly, wait at least 30 minutes before filling the engine with oil.

    (Refer to Lubrication System - "ENGINE OIL ")

  3. Install all other parts in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.