Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Verification Of Vehicle Repair
2020 Genesis G90 3.3T Premium, AWDSECTION Verification Of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
- Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
- Erase the DTCs and Operate the vehicle within DTC Enable conditions in General information.
- Is any DTC output again?
YES
- Go to the applicable troubleshooting procedure.
NO
- System performing to specification at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.