Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSGENESIS2020G90 3.3T PREMIUM, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASPARKING DISTANCE WARNING SYSTEM DIAGNOSISDTC C1375-96: PDW SENSOR - FRONT LEFT OUTER (HW)DTC INSPECTIONMONITOR DTC STATUS
2020 Genesis G90 3.3T Premium, AWD
Monitor DTC Status
2020 Genesis G90 3.3T Premium, AWDSECTION Monitor DTC Status
- Connect GDS to Data Link Connector (DLC).
- Turn the engine ON
- Select the "Front left outer sensor" on the "Current Data".
- See if there is any change with or without objects in front of the sensors.
- Does the output of the "Front left outer sensor" fluctuate within the specification values?
YES
- The fault can be intermittent, caused by poor contact of connectors between the ADAS_PRK (Parking Collision Avoidance Assist Unit) and Sensor wire harness. Or the ADAS_PRK (Parking Collision Avoidance Assist Unit) memory was not cleared after repair. Thoroughly check connectors for looseness, poor contact, bending, corrosion, contamination, deterioration, or damage. Repair or replace relevant component as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to next procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.